Place the spa on an approved surface and have it properly wired by a licensed electrician.
For DURA-LAST™ models, remove exterior spa panels by inserting a flathead screwdriver at bottom edge of the panel and prying it out. For ULTRA-TEC models, remove screws that hold the side panels in place. For Durasport models, unlock and open the access door.
Make sure white plumbing unions are secure and did not loosen during shipping. There will be 4 unions on a 1-pump spa and 6 unions on a 2-pump spa. Hand-tighten any loose unions.
Open all gate valves in the equipment area. Before operation, these valves must be in the UP/OPEN position and have plastic clips inserted. Never run the spa with the gate valves closed or without water circulating for any period of time.
Remove the filter(s) (and wire and basket, if equipped) from the filter chamber.
Place a garden hose in the filter chamber and fill your spa with regular tap water to 2” higher than the highest jet (excluding neck/shoulder jets).
NOTE: Do not fill your spa with soft water. It is difficult to maintain proper water chemistry with soft water. Also, the water may foam, which will eventually harm the finish of the spa and void your warranty.
Once the water is at the correct level and air is bled, turn on the power at the GFCI breaker.
NOTE: When the power is turned on, the controls will per¬form a diagnostic check for a few minutes. When complete, the spa will automatically operate at filter speed and continue heating until water reaches 100ºF.
If water does not flow from the jets when the pump is running, there could be an air pocket. See the “Priming the Pump” section below for methods of removing air pockets from the pump(s).
Install the filter(s) (and weir and basket, if equipped) into the filter chamber.
Operating Your Hot Tub
Priming the Pump
Sometimes air can become trapped in the pump while filling the hot tub. You will know this has happened when after filling and starting the spa, the pump does not function. You will hear the pump operating, but no water will be moving. The pump will not work properly while air is trapped in it. DO NOT continue to operate the pump this way or it will cause damage to the spa.
New spa owners often have difficulty the first time they start their spa and the pump fails to prime. This can be frustrating, but these simple instructions can help you.
Remove air bubbles trapped in the hot tub pump:
Turn the spa on and wait for PR (Priming Mode) to appear on the topside display.
Press the JETS1 button to turn on the pump, then let it run for 10 seconds. The pump should be running on low speed.
Press the JETS1 buttons again and let the pump run on high speed for 10 seconds.
Press the JETS1 button again to turn off the pump. The pump should be left in the off position for 10 to 15 seconds.
Repeat steps 1 through 4 until water is flowing through all the jets and all the air is removed from the plumbing.
Remove a large air lock within the hot tub pump:
Turn off power at the breaker.
Remove the hot tub panel closest to the pump.
Loosen the white pressure union on the top of the pump by hand or with a strap wrench. When air is bled out, tighten the union, turn the breaker on and set the pump on high speed. NOTE: If you press the “Temp” button any time during Priming Mode, it will exit that mode and begin Standard Mode.