It’s easy to install a Strong spa. For your convenience, we’ve given you the step-by-step instructions below. If at any time you have difficulty installing your hot tub or have a question, don’t hesitate to contact our no-hassle team. They’re standing by just waiting to help you.
Plan your installation carefully, from your entire visit on our website to the final placement of your hot tub. Select the easiest route on your property to the install site, making note of tight turns or obstacles that may require lifting to get over or around.
Prepare a level surface for our base to rest on. Learn how to determine the best location for your spa.
The certified electrician should pre-install a 240-volt, 50 or 60 amp electrical service attached to a ground fault interrupt circuit from a safe distance from the tub.
Carry the hot tub or use a flatbed truck capable of supporting the weight and dimensions of the hot tub and drive it as close to the installation site as possible.
Arrange to have a few strong people on hand for a short period, to off load the spa and transport it by hand the rest of the way.
Connect all pumps, hoses, cut-off valves and any other connections specific to that particular hot tub model.
Fill the hot tub with a garden hose using cold water until reaching the fill line, which is normally 2 inches above the highest jet.
Instruct the electrician to hook up the electric service and then follow manufacturer instructions on initial startup of that particular model.
Try all jets, pumps, lights and features to determine if all are working correctly. Set the thermostat to 100 degrees and make sure the heater works.
Treat the hot tub chemically and place the hot tub cover on the tub to retain the heat until you reach the desired temperature.
Save all Strong Spa paperwork, such as instructions, warranty card and model information regarding your hot tub. If you have any questions please feel free to contact our No-Hassle Team and we will be glad to help you out.